Axis Wakeboard Boat Forum

I had bought the large ones from bakes. However, I have not been able to find any of the small ones online that match the correct diameter exactly. I could find some for poker tables that are slightly larger but would require me to open up the holes in the boat by 1/8"-1/4"....gonna ask the dealer if I can just order the small ones through them.

Can you let me know what you find? I was thinking about getting them as well.

Definitely. I'll post something up on this thread.

The stainless cups are sold on Amazon differernt sizes.

You can buy LED rings to fit the smaller cup holders. I dont know the exact hole opening for either size, anyone know both sizes?

I was primarily looking to buy Stainless Cup Holders with LEDs, but only in one size that I've found, about $35-40 each, NOT on Amazon. onlyinboards.com is the cheapest and almost complete (don't offer subwoofer speaker rings). earmarkcaraudio.com is the most complete, fair prices, empirehydrosports.com, less complete, good pricing.

3 5/8" mounting hole, 4 5/8" outside diameter
http://store.earmarkcaraudio.com/Xcart/ ... 265&page=1

The intial thread, I missed one at the rear of driver's seat.

So I believe on the T22 there are 16 total:
--------------------
(4) Smaller, around 3+ inches:
2 stern
2 driver's seat

(12) Larger, around 4":
2 swim platform
5 behind the driver's seat
3 on the passenger's seat
2 at the bow (not sure if these are the smaller ones or not)

I'm working on details for a package deal for LED cup holders w/rings and the wetsounds system. Might be an opportunity for a group buy here ... I'll ask the vendor and get approval from the admin moderator here if so.

Canned the idea of buy them and am building them instead. I purchased several components from Hitlights via Amazon.

If someone has a micrometer, could you please measure the diameter of one small AND large cup holder?

I have a schematic for the system and parts list.

The most difficult steps are learning to solder the small LED RGB connections and cutting the circles for the cup holders. Since I don't ahve the boat yet (due in the end of June), can't figure out how I'll do the Wetsounds speakers yet.

I'll post vids on each step later.

Wetsounds sub done ... 10 speakers and 16 cup holders to go!

I chose RGB, added a music controller, wired into the ACC switch.

The LED ring is 1/2 cast acrylic.

I've found I'll be soldering a 12" wire lead onto each LED rather than adding multiple snap connectors onto each LED then again another connector onto the main feed.

They're RGB with a music controller ... still need to do the REV410's in the tower and the transom sony remote

few more pics .... there's a special piece for the rev410s needed, that's on order. an rgb 6 way connector.

Wow! Awesome!

Looks great! If you were to post up your schematic, I would not be upset at all . Plan to do some of this soon..