Axis Wakeboard Boat Forum

My 2015 A20 sucks up too much debri and constantly overheats. Bought an Indmar Pro Strainer and installed it. Here are some pics if anyone is thinking of installing it.

Tools- Hacksaw, flat head screwdriver.
When you cut out a portion of the intake hose the hacksaw works great, be careful of the wire- its sharp when you cut it and got me a couple times. Error on the side of cutting too little of the hose.

Review- Works great, easy to install, can clean out debris in 30 seconds and be boating again. Hose attachment is great for dry starts.

Only con I can see so far is the plastic it's made out of. Not sure how long it will last before cracking. Cost was about $90ish for the entire project.


Sent from my iPhone using Tapatalk

i have had mine for a two summers and it works great. easy cleanup and great for winterizing.. where do you surf? the water is so brown?

We surf / boat at Lake Nacimiento. It's near Paso Robles in Cali. The Strainer has been a welcome addition! Saving me a ton of busted knuckles trying to get to the oem debri screen.


Sent from my iPhone using Tapatalk

Good to know. Thanks for sharing your experiences Rmil. I might get it myself.

Can you please explain the routing for me? Isn't the intake supposed to route to the water pump? I would like to tackle this project before next winter...

The water comes in and goes thru the v-drive, then the transmission cooler then back to the water pump.