|
It is currently Wed Dec 25, 2024 2:41 pm
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 2 posts ] |
|
Author |
Message |
pilotflying
|
Post subject: How do I use the ACC switches? Posted: Fri Apr 01, 2016 10:10 am |
|
|
Team Axis |
Joined: Thu Oct 30, 2014 7:24 am Posts: 88 Location: Germany
|
I would like to control my DIY-LED-install with one of the ACC switches. I have looked behind the dash and was surprised to see three cables going to each of the ACC Switches. I wouldn't have expected them to have cables at all. These cables lead to a connector which goes into what looks like the main cable bus of the boat. On the circuit breaker Panel I have found CBs for both ACC Switches. My question is where is the correct point to tap into the ACC Switches so I can also make use of the factory CBs?
_________________ 2014 A22
|
|
Top |
|
|
alexandera
|
Post subject: Re: How do I use the ACC switches? Posted: Sun Apr 03, 2016 8:30 am |
|
|
Team Axis |
Joined: Sun Sep 16, 2012 8:55 am Posts: 375 Location: Central Texas
|
The single throw acc switch should already have a ground and a hot connected to it. The ground may even be piggybacked to another adjacent switch.
You should have one blank blade ready to receive a female connector. Pull your new wire for your accessory and attach the hot to the blank blade and splice into the ground with a t-tap connector. Use a minimum of 16AWG wire to minimize resistance.
Double-throw is a little more complicated, but same concept, depending on how the double-throw operates. (on1-off-on2 vs. on1-off-on1+2).
_________________ -aha-
18 Monterey 278SSC
|
|
Top |
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 35 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|