|
It is currently Thu Dec 26, 2024 11:06 am
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
arkryder
|
Post subject: Bad pop on rev10 at medium volume  Posted: Sun Jul 05, 2015 11:19 am |
|
Joined: Sun Nov 04, 2012 8:36 pm
Posts: 7
Location: marianna arkansas
|
|
Newly installed rev10 have a bad pop when speakers are at medium volume. Any info would be appreciated. Got a pair of rev10 and replaced my stock Titan speakers also got a wetsounds sd2 amplifier had four different speaker wires going to old speakers and instead of not using two wires I just ohmed everything out and ran each speaker from two sets of speaker wires(if that makes sense so far). The amp I installed is supposed to be tuned for rev10 already. On the amplifier side I have speakers bridged. Don't know if this could be problem but don't know today I am going to try to run both speakers off channel one only and see if this helps. Sucks spending all this money and speakers popping.
|
|
| Top |
|
 |
|
arkryder
|
Post subject: Re: Bad pop on rev10 at medium volume Posted: Tue Jul 07, 2015 6:40 pm |
|
Joined: Sun Nov 04, 2012 8:36 pm
Posts: 7
Location: marianna arkansas
|
|
Just so everyone knows I found my popping noise it was my cabin speakers turned my gain all the way down on them and cleared it out.
|
|
| Top |
|
|
|
AJWest
|
Post subject: Re: Bad pop on rev10 at medium volume Posted: Tue Jul 07, 2015 6:43 pm |
|
 |
| Team Axis |
Joined: Mon May 23, 2011 11:02 am
Posts: 1849
Location: Copperas Cove, TX
|
|
Improperly set gains can cause havoc in a stereo
_________________
2014 A24
2011 A22 (sad to see her go)
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 14 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
