Is it possible to wake surf a 2017 T22 with hard tank ballas

r33pwrd · **Posted:** Thu Feb 08, 2018 6:15 pm

MattSh wrote:

Can someone confirm this for me?
Can you simply unclip and then take the bags out of the rear lockers and leave the P&P tubing free, without issues of leakage. Specifically a recent model Axis with factory P&P?

Sent from my iPhone using Tapatalk

Yes you can. Most boats are shipped this way.

Sent from my SM-G955U using Tapatalk

MattSh · **Joined:** Wed Jan 17, 2018 6:11 am **Posts:** 31

Hi Johnny
I agree, it can’t have saved them much money by getting the tubing back, considering the labour time.
As far as I am aware P&P uses the preexisting infill and outflow pumps already attached to the hard tanks. It piggybacks off these. So they remain.

Sent from my iPhone using Tapatalk

MattSh · **Joined:** Wed Jan 17, 2018 6:11 am **Posts:** 31

shawndoggy wrote:

Yes. All PNP boats ship that way from the factory b/c PNP bags are an "at the dealer" add on (like batteries). There are "dummy plugs" that get plugged into the ends of the PNP plumbing that would otherwise connect to the bag.

I'd be very surprised if your bow ballast pump and plumbing weren't already installed as well.

All the wiring is there ready for bow ballast, but no pumps.

Sent from my iPhone using Tapatalk

MattSh · **Joined:** Wed Jan 17, 2018 6:11 am **Posts:** 31

r33pwrd wrote:

MattSh wrote:

Can someone confirm this for me?
Can you simply unclip and then take the bags out of the rear lockers and leave the P&P tubing free, without issues of leakage. Specifically a recent model Axis with factory P&P?

Sent from my iPhone using Tapatalk

Yes you can. Most boats are shipped this way.

Sent from my SM-G955U using Tapatalk

So it was pretty cynical of them pulling all the P&P plumbing rather than just capping them off!

Sent from my iPhone using Tapatalk

r33pwrd · **Posted:** Thu Feb 08, 2018 11:48 pm

MattSh wrote:

r33pwrd wrote:

MattSh wrote:

Can someone confirm this for me?
Can you simply unclip and then take the bags out of the rear lockers and leave the P&P tubing free, without issues of leakage. Specifically a recent model Axis with factory P&P?

Sent from my iPhone using Tapatalk

Yes you can. Most boats are shipped this way.

Sent from my SM-G955U using Tapatalk

So it was pretty cynical of them pulling all the P&P plumbing rather than just capping them off!

Sent from my iPhone using Tapatalk

I would say yes.. they more or less removed a factory installed part.. are you sure they actually pulled the pumps and lines not just the bags? Really though not hard or that expensive to add the stuff back..

Sent from my SM-G955U using Tapatalk

Axis Wakeboard Boat Forum

Is it possible to wake surf a 2017 T22 with hard tank ballas

Who is online